![darkroom booth 3 manual darkroom booth 3 manual](https://www.imagingspectrum.com/images/P/booth3-ds40-bndl.jpg)
the color you are adjusting to in order to achieve neutral white
![darkroom booth 3 manual darkroom booth 3 manual](https://getpaddee.com/wp-content/uploads/2018/01/9-1024x653.png)
hide built-in presets for processing modules If enabled, only user-defined presets will be shown in the presets menu for processing modules – built-in presets will be hidden (default off). You can choose between “false color” and “gray scale” (default “false color”). ?modules display of individual color channels Control how individual color channels are displayed when activated in the parametric masks feature. Note that switching this option off can be very useful to quickly compare duplicate images, however, there might be issues with long loading times (leading you to think the next image has already loaded) and you may observe visual artifacts while the next image is loading (default on). Switch this option off to just show a simple toast message and leave the previous image in place until the next image is loaded. show loading screen between images Show gray loading screen when navigating between images in the darkroom. This may improve the speed of the rendering but take care as it can also hinder accurate color-picking and masking (default “original”). reduce resolution of preview image Reduce the resolution of the navigation preview image (choose from “original”, “1/2”, “1/3” or “1/4” size).
Darkroom booth 3 manual full#
full (possibly slow) will use the settings from the demosaic module.X-Trans sensors will use VNG as the middle-ground setting. at most RCD (reasonable) uses RCD + interpolation modes.always bilinear (fast) is fastest, but not as sharp.Note: this setting is only used for interactive work and does not affect exported images.
Darkroom booth 3 manual how to#
demosaicing for zoomed out darkroom mode Choose how to demosaic images in the darkroom view when not viewing the image at 1:1 zoom scale. show scrollbars for center view Choose whether to show scrollbars in the center view of the darkroom (default off). border around image in darkroom mode Display the center image in darkroom mode with an outside border of the given number of pixels (default 20). Choose between “top left” “top right” “top center” “bottom” and “hidden” (default “bottom”). position of the image information line Choose the darkroom panel in which the image information line is displayed. You can use any variables in the variables section as well as $(NL) for a new line. pattern for the image information line Set the information to be displayed in the image information line. Stronger smoothing leads to fewer nodes and easier editing at the expense of lower accuracy. smoothing of brush strokes Sets the level for smoothing of drawn mask brush strokes. “Relative” means that the pressure reading adjusts the attribute between zero and the pre-defined default value (default off). “Absolute” control means that the pressure reading directly defines the attribute with a value between 0% and 100%. You can control the brush width, hardness and opacity. ?general pen pressure control for brush masks Controls how the pressure reading of a graphics tablet impacts newly generated drawn mask brush strokes. Control functionality in the darkroom view and associated modules.